Here are instructions for the search coil of the metal detector above. It requires 70 turns of 30 swg (22 awg) enamelled copper wire on a 120 mm (4¾") diameter former. Neither the winding of the coil nor the wire gauge are critical. Wind the coil around the former, and temporarily hold it together with stubs of insulating tape. Then bind it tightly with insulating tape all round. Scrape the enamel off the ends of the coil's enamelled copper wires. Then add a Faraday electrostatic shield, for stability. Prepare some long, thin strips of tin foil. Twist a 100 mm (4") length of bare wire around the coil, over the insulating tape. This provides electrical contact with the foil. Now wind the foil around the circumference of the coil -- beginning at the base of the bare wire -- yet the foil should not quite complete a full 360°. Leave a small gap as shown. Now tightly bind the whole Faraday shield with insulating tape. Attach the coil to IC1 by means of microphone cable, with the cable's screen(s) going to the Faraday shield at the one end, and to -6V (negative) at the other. The coil may be mounted on a rigid plate, and a suitable handle attached. OBSERVATION: Click on the diagram to blow it up. You could wire the coil directly to the circuit if you're in a hurry.
NOTE: You may re-publish this design, on condition that you acknowledge the designer (Thomas Scarborough) and this blog (http://thomasscarborough.blogspot.com).
U r a nice man. Thank u.
I lost my ring in a volleyball court & came across Metal Detectors site. Like everyone has said here, money well spent and saved me really! I was very appreciative of all of the helpful advice on how to use it. He was very nice & helped us find my rind and it was quick... Highly recommended!
Can i use alluminium foil from broken down capacitor for faraday shield ?
Yes. So long as the foil conducts from beginning to end. There should not be an electrical break, except for the gap in the Faraday shield.
Post a Comment